Steel Detailing vs. Connection Design: When Your Shop Drawings Become Engineering

Short answer

Detailers turn the engineer’s design into fabrication drawings. When a contract asks for steel detailer connection design, that is usually delegated design, which may require a licensed engineer and a policy that covers engineering services. Whether a policy responds depends on its wording and the facts.

General education, not legal advice. Hardcover is an insurance agency, not a law firm.

What detailers do vs. what engineers do

A steel detailer produces shop drawings and erection drawings. These drawings show fabricators how to cut, fit and assemble each piece, and they show erectors where each piece goes. The detailer follows the engineer’s design and the contract documents.

An engineer designs the structure and decides the loads, member sizes and connection requirements. Connection design means working out the forces a joint must carry and sizing the bolts, welds and plates. That step involves engineering judgment, which sets it apart from detailing. Steel detailer connection design therefore sits on the engineering side of the line.

If you are starting a detailing shop, see our steel detailing company insurance guide.

How delegated design reaches the detailer

Specifications sometimes delegate connection design to the fabricator. The fabricator then passes the work to the detailer, and the detailer may be asked to “just size the connections.” Each handoff moves responsibility further from the engineer of record.

That chain is how detailers end up doing engineering work without intending to. The contract language matters at every step. Our article on what liability you take on when you stamp engineering drawings explains how stamping connects to responsibility, and stamping someone else’s design covers a related risk. Engineers who review detailer work should know who actually designed each connection.

Why steel detailer connection design matters for insurance

A policy covers the professional services it describes. Work outside that description may not be covered, depending on the policy wording. A detailing policy that lists drafting and detailing may not describe engineering services at all.

Underwriters price detailing and engineering differently, because the exposure differs. A connection failure can mean serious loss, so insurers want to know which work you perform. Our article on the definition of professional services in an engineer’s E&O policy shows why the wording matters. Whether a policy responds depends on its wording and the facts.

What to do before you agree

Slow down when a client asks you to size connections. A few steps can protect both your license position and your insurance.

  • Read the scope and the specification for any connection design language.
  • Ask who designs the connections and who stamps them.
  • Tell your agent what you were asked to do, in plain words.
  • Confirm in writing that your policy describes the services you will perform.

Our guide to the insurance section of your contract helps you spot related requirements. Hardcover works with more than 600 A&E firms, and detailers raise this question often.

Questions to ask your agent

A good agent will ask what you detail and what you do not. Your answers shape the policy description. You can ask your own questions in return.

  • Does my policy describe detailing only, or engineering too?
  • What happens if a client asks me to size connections?
  • Does the policy require a licensed engineer to review connection work?

Can a detailer legally design connections?

It depends on the state and the project. Often a licensed engineer must do it. Check with your state board before you accept the work.

Does my detailing policy cover a connection failure?

It depends on the policy’s definition of your services and the facts. A policy that lists detailing only may not respond to engineering work. Ask your agent to review the wording.

Contract check

Send us the contract before you sign.

We read the insurance and indemnity sections against your actual policies and tell you what we see.

For your firm

More for Your Discipline.

How coverage works for each kind of firm, what underwriters ask, and the claims that come up.

This article is general information, not insurance or legal advice. Coverage depends on the terms, conditions and exclusions of your policy as issued.